Medical Service^TM

Country: 40.127.139.252, Europe, IE

City: -6.2595 Leinster, Ireland

The filament arrived promptly and was of a very high quality. I work in a robotics lab and order a large variety of filaments keeping my eye out for the best and this is toward the top of the list in the ABS category. One of the cleanest spooled filaments I've used came of the spool in perfectly layered helix's and produced beautiful prints. Never came remotely close to getting tangled on the spool like many low quality filaments can tend to do. Also have never experienced a jam using our Taz 5 printer with this filament. Build plate 110C, nozzle at 240C as well as a boxed enclosure to raise the ambient temp produced warp free large prints.

Keeping in mind that I was using it on cans of 3M 08881 car body undercoating, which I'm sure it was not intended for, it did clog up enough that the cans stopped spraying about halfway thru. By experimenting.....since I'd not taken the time to find any of the recommended cleaner (live out in the sticks)....found that when it did that, spraying both the tool and the spray part of the can with something called "Goo Gone", it would resume. Had some left in the last can, so cleared it as recommeded (spray with the can held upside down until only air comes out), then filled the small inside ring of the can cover with Goo Gone, put it on the can, and stored it standing on its head overnight. Checked it a week later and the can was still working, so it's good to go when I want to do the overlaps on my stock horse trailer roof. On a regular paint can, it may not plug. Haven't tried it there....yet. Even plugging up, it sure beats holding that button down with your finger!